View Single Post
Unread 11-28-2017, 11:05 PM   #3
volcom15
Cadet
 
Join Date: Nov 2017
Fan#: 4648
Location: Caguas, PR
What I Drive: 1992

Posts: 2
Rep Power: 0
volcom15 Good Standing Member
Hi,thanks for helping me out,my heads are aftermarket heads,aluminum heads with 2.02 1.60 valves very very extensive modification done to it,they are about 56cc,i put this head in my mustang heavy weight no weight taken off with 373 gear on pump gas and ran quickly in the 12 in the 1/4,the short block its 302 std bore and the compression is 190 in all of them,the car right now i have taken from it a lot of weight,i change the gear to 410,the plenum before this with a gt 40,but i habe niw change it for a trick flow track heat,the new short block still be 302 std bore but i replace the factory piston for a ross dome .200 one,i also have a .440 dome piston but with that cam theres and these heads will not work since the dome is too high and theres no piston to valve clearence,so i have to use the .200 to work fine with the .595 lift,any comment its a great help
volcom15 is offline  
Reply With Quote